F 450 2WD Super Duty V10-6.8L VIN V (2005)
8. Remove the switch cover and the clutch pedal position switch from the clutch master cylinder push rod.
9. Separate the power distribution box from the bracket to gain access to the clutch master cylinder.
10. Remove the clutch master cylinder from the clutch pedal and support bracket, then remove the two outer clutch pedal support bracket nuts.
1
Compress and twist the clutch master cylinder clockwise 45 degrees to unlock it from the clutch pedal and support bracket.
2
Remove the nuts.
11. Remove the inner clutch pedal and support bracket nuts and the clutch pedal and support bracket.
12. CAUTION: When installed correctly, the flat side of the clutch pedal position switch must face the tab protruding from the clutch master cylinder
, and the switch wiring connector must be in the 12 o'clock position. Incorrect installation will damage the clutch pedal position switch and cause
insufficient clutch pedal travel.
To install, reverse the removal procedure noting the following:
^
Correctly position the clutch pedal position switch when installing it on the clutch master cylinder push rod.
