F 450 2WD Super Duty V10-6.8L VIN V (2005)
2
Separate the driveshaft slip yoke from the stub shaft.
4. Remove and discard the driveshaft slip yoke boot.
5. Check the lubricant for contamination. If the lubricant feels gritty, clean and inspect the stub shaft and driveshaft slip yoke for wear. Install new
components as necessary.
Assembly
All driveshafts
1. Fill the driveshaft slip yoke boot with approximately 10 grams (0.36 ounce) of grease.
2. Position the driveshaft slip yoke boot clamp on the stub shaft.
