F 450 2WD Super Duty V10-6.8L VIN V (2005)
Universal Joint: Service and Repair
Driveshaft Universal Joint - Front Slip Yoke
Driveshaft Universal Joint - Front Slip Yoke
Disassembly
Initial disassembly
1. NOTICE: Do not, under any circumstance, clamp the shaft in the jaws of a vise or similar holding fixture. Denting or localizing fracture
can result, causing shaft failure during vehicle operation.
Place the shaft on a suitable workbench. Do not damage the tube.
2. Remove and discard 2 snap rings.
3. Clamp the C-Frame and Screw Installer/Remover in a vise.
Bearing cup removal
4. NOTE: If necessary, use a pair of pliers to remove a bearing cup that fails to press out all the way.