F 450 2WD Super Duty V10-6.8L VIN V (2005)
4
Press the bearing cup to just below the snap ring groove.
^
Repeat to install the new bearing cup on the opposite side of the driveshaft yoke.
Flange installation
2. Inspect the flange. Install a new flange, if necessary.
3. Install the new bearing cups and the flange.
1
Start a new bearing cup in the flange.
^
Check the needle bearings for correct positioning.
2
Position the flange on the spider.
3
Position the assembly in the special tool.
4
Press the bearing cup to just below the snap ring groove.
^
Repeat to install the new bearing cup on the opposite side of the flange.
Final assembly
4. NOTE: Use the yellow snap rings supplied in the kit to assemble the universal Joint (U-joint). If difficulty is encountered with the yellow snap
rings, install the black snap rings.
Remove the driveshaft from the C-Frame and Screw Installer/Remover, and install the 4 new snap rings.
5. CAUTION: Do not strike the bearings. Damage to the bearings may occur.
Check the U-Joint for freedom of movement.
^
If binding, strike the yoke with a brass or plastic hammer.
