F 450 2WD Super Duty V10-6.8L VIN V (2005)
3. Remove all of the snap rings.
4. Clamp the special tool in a swivel base vise.
5. CAUTION: Do not continue to tighten the special tool if the U-joint bottoms out in the yoke or damage will occur to the center bearing shield.
Using the special tool, press the 2 bearing cups out of the opposite side of the driveshaft center yoke.
^
Alternate the pressure between the U-joints.
6. Slide the universal Joint spider toward the screw side of the special tool. Insert the half moon punch on the exposed spider leg.
7. Using the special tool, press the 2 remaining bearing cups out of the opposite side of the driveshaft center yoke.