F 450 2WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
Assemble the small end of the tapered spring onto the pin on the relief valve cartridge and insert the assembly (large end of tapered spring end
first) into the relief valve cap cavity.
-
Turn the relief valve cap as assembled into the valve housing and tighten to specification.
19. CAUTION: This bearing is sealed and will receive no lubrication from the hydraulic fluid in the gear. Failure to use the correct grease can result
in premature bearing wear.
Lubricate the DU bushing or the bearing assembly.
-
For TAS4O, lightly oil the DU bushing but do not grease.
20. Grease and assemble a new seal onto Bearing and Seal Installation Tool so the side with the garter spring is against the shoulder of the installation
tool.
-
Pilot the tool into the side cover with a force of 445-3,560 N (100-800 lb) until it is seated against the bearing or bushing.
21. Lubricate the sector shaft.
-
For TAS4O, lightly oil the short bearing area of the sector shaft but do not grease.
22. Insert the sector shaft into the side cover subassembly and screw the sector shaft adjusting screw counterclockwise into the side cover until the
screw reaches solid height.
