F 450 2WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
Clutch Master Cylinder: Service and Repair
Clutch Master Cylinder and Reservoir
MATERIAL
Removal
CAUTION: Remove the entire clutch hydraulic system from the vehicle as an assembly when installing a new clutch master cylinder assembly.
1. Disconnect the clutch hydraulic tube from the dash clip.
2. Raise and support the vehicle.
3. Unlock and remove the slave cylinder from the transmission.
^
Compress and twist the slave cylinder to unlock it from the transmission.
4. Disconnect the clutch hydraulic tube from the floor pan clip. Position the slave cylinder and hydraulic tube forward below the left engine bank.
This will make it easier to unlock the clutch master cylinder from the clutch pedal and support bracket by reducing tension on the hydraulic tube.
5. Lower the vehicle.
6. WARNING: The clutch pedal is under spring tension.
