F 450 2WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
8. Install the special tool.
1
Position the special tool.
2
Install the bearing caps.
3
Install the four bolts.
9. NOTE: Use a feeler gauge or flat, clean drive pinion position shims as a measuring device.
NOTE: Do not attempt to force the gauge or shim between the Gauge Block and the Gauge Tube. A slight drag indicates a correct selection.
Using a feeler gauge or flat, clean drive pinion position shims, measure between the Gauge Block and the Gauge Tube. Record the measurement.
^
Remove the special tools after making the correct shim selection.
10. CAUTION: Follow the drive pinion bearing preload shim and drive pinion position shim assembly sequence as directed or unit failure can result.
Install the correct thickness drive pinion position shim, and the oil slinger, if so equipped, on the pinion.
11. NOTE: Always use the same new inner pinion bearing installed when taking the measurement for drive pinion position shim selection.
Using the special tool, an axle bearing/seal plate, and a suitable press, install the pinion bearing.
12. NOTE: Use the thickness of the old drive pinion bearing preload shims as a starting point for setting pinion bearing preload.
Inspect the drive pinion bearing preload shims for damage. Discard them if necessary. New shims are available in the thickness shown in the
following chart.
Available Drive Pinion Bearing Preload Shims
Available Drive Pinion Bearing Preload Shims
