F 450 2WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
Excursion
9. CAUTION: The driveshaft yoke fits tightly on the rear axle pinion flange pilot. Never hammer on the driveshaft or any of its components to
disconnect the yoke from the flange. Pry only in the slot on each side of the driveshaft yoke, with a suitable tool, to disconnect the yoke from the
flange.
Using a suitable tool, disconnect the driveshaft yoke from the rear axle pinion flange, and remove the driveshaft from the vehicle.
Installation
All vehicles
1. CAUTION: Align the index marks.
Position the driveshaft yoke on the transfer case flange.
All vehicles, except Excursion
2. Remove the tape from the bearing cups.
3. CAUTION: Align the index marks. Position the bearing cups in the rear axle pinion flange.
