F 450 2WD Super Duty V8-5.4L SOHC VIN L (2003)
11. Remove the clutch hydraulic reservoir. Position the clutch hydraulic reservoir aside.
^
For 5.4L, 6.8L and 7.3L vehicles, remove the reservoir from the wiring tray and separate the clutch hydraulic tube from the brake master
cylinder.
^
For 6.0L vehicles, remove the reservoir from the power steering reservoir.
12. CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, wash the surface with
water immediately.
Remove the clutch hydraulic system from the vehicle.
13. Clean the clutch hydraulic system components to prevent contaminants from entering the hydraulic system.
14. CAUTION: Place a suitable container under the clutch master cylinder.
Disconnect the hydraulic tube from the clutch master cylinder.
1
Using a 3/32-inch punch and a hammer, drive out the roll pin, and discard it.
2
Disconnect the hydraulic tube from the clutch master cylinder.
15. NOTE: Sometimes the O-ring seal will remain inside the clutch master cylinder.
