F 450 2WD Super Duty V8-5.4L SOHC VIN L (2003)
4. NOTE: Index-mark the driveshaft to transfer case or transmission flange.
For four-wheel drive vehicles, or vehicles equipped with a circular flange, disconnect the driveshaft from the transfer case or transmission.
^
Remove and discard the bolts.
^
Using mechanics wire, support the driveshaft.
5. For vehicles with a slip yoke at the transmission, index-mark the output shaft to the slip yoke.
6. Remove the center bearing support bolts.
7. Remove the driveshaft assembly.
8. Clean grease deposits, dirt and rust from the following:
^
The driveshaft yoke areas.
^
All driveshaft components.
^
Wipe the bearing and rubber insulator of the driveshaft center bearing. Do not immerse in solvent.
9. Inspect the following:
^
The driveshaft slip yoke boot for rips or holes. Install a new boot if necessary.
^
The driveshaft center bearing support for wear or rough action. If roughness or wear is evident, install a new driveshaft center bearing support.
^
The center bearing rubber insulator for evidence of hardening, cracking or deterioration. Install a new insulator if necessary.
