F 450 2WD Super Duty V8-5.4L SOHC VIN L (2003)
Opposite bearing cup installation
3. Repeat Bearing cup installation in this procedure to install the new bearing cup and snap ring on the opposite side of the shaft yoke
Slip-yoke installation
4. Inspect the driveshaft slip-yoke. Install a new yoke, if necessary.
5. Install the driveshaft slip-yoke and new bearing cup.
1
Start a new bearing cup in the driveshaft slip-yoke.
^
Check the needle bearings for correct positioning.
2
Position the driveshaft slip-yoke on the spider.
3
Position the assembly in the special tool.
4
Press the bearing cup to just below the snap ring groove.
6. Remove the shaft from the special tool, and install the new snap ring.
Opposite bearing cup installation
7. Repeat Slip-yoke installation in this procedure to install the new bearing cup and snap ring on the opposite side of the driveshaft slip-yoke.
