F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
Sunroof / Moonroof Panel: Service and Repair
ROOF OPENING PANEL
Removal and Installation
NOTE: The roof opening panel must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof
opening panel has been removed from the roof opening panel assembly, a new roof opening panel motor/module has been installed or when a new roof
opening panel assembly has been installed.
1. Position the roof opening panel in the VENT position.
2. Remove the 4 roof opening panel bolts.
-
To install, tighten to 4 Nm (35 lb-in).
3. Remove the roof opening panel from the outside of the vehicle by lifting up and out.
4. To install, reverse the removal procedure.
-
Adjust the roof opening panel.