F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
Parking Brake Cable: Service and Repair
Parking Brake Cable Tension Release
Parking Brake Cable Tension Release
1. Remove the LH cowl side trim panel. For additional information, refer to Trim Panel.
2. With an assistant, release the parking brake cable tension by pulling down on the intermediate cable at the cable-to-cable union until the parking
brake control sector rotates to its stop and a 4 mm (0.15 inch) x 15 0 mm (5.9 inch) retainer pin can be inserted.
3. Disconnect the cable at the cable-to-cable union.
4. NOTE: Make sure the cable-to-cable union is connected to the front and rear cable before removing the brake control retaining pin, and the cable
tension is reloaded slowly.
To reload the tension on the parking brake cable, reverse the release procedure.
