F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
Vehicles with dual generator
4. Rotate the tensioner clockwise and remove the dual generator accessory drive belt.
5. Remove the 3 bolts and the dual generator pulley.
All vehicles
6. Rotate the tensioner clockwise and remove the accessory drive belt.
7. Check the crankshaft vibration damper runout.
^
Remove the paint from the face of the crankshaft vibration damper at 4 points 90 degrees apart.
^
Attach the special tool to the cylinder block. Position the special tool on one of the unpainted surfaces.
^
Using a suitable tool, pry the crankshaft forward. Zero the dial indicator.
^
NOTE: Pry the crankshaft forward only to eliminate possible error caused by crankshaft end play.
Rotate the crankshaft 90 degrees. Pry the crankshaft forward. Record the measurement. Repeat at each unpainted surface.
^
If the runout exceeds specification, install a new crankshaft vibration damper.
8. WARNING: To avoid personal injury, support the vibration damper during mounting bolt removal. The damper can slide off the nose of
the crankshaft very easily.
Remove the 4 bolts and the crankshaft vibration damper.
^
Discard the bolts.
Installation
All vehicles
