F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
Rocker Arm Assembly: Service and Repair
Rocker Arm Cleaning and Inspection
Rocker Arm Cleaning and Inspection
Material
1. Disassemble the rocker arm from the fulcrum plate. With the rocker arm and fulcrum plate upside down in your palm, push down the fulcrum
plate. Using your palm, move the rocker arm away from the rocker arm ball and off of the fulcrum plate.
2. NOTE: Be careful when removing the rocker arm. Do not lose the rocker arm ball.
Move the rocker off the ball, keeping the ball in the detent of the fulcrum plate. Remove the rocker arm ball.
3. Remove and discard the rocker arm clip.
4. Clean all parts with a suitable solvent. Use filtered compressed air to dry the parts.
^
Inspect each rocker arm pivot foot and corresponding valve bridge for pitting and scuffing. Inspect each rocker arm ball and socket for
scuffing. Install new rocker arms and valve bridges as required.
^
Inspect the rocker arm post ball socket for excessive wear. Inspect bolts for thread damage, install new components if worn or damaged.
