F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
3. CAUTION: To prevent engine damage, keep the push rods in the order in which they were removed. Install all push rods back in their original
positions.
NOTE: On early build vehicles, higher mileage engines require push rods to be cleaned so the copper-colored end of the push rod can be
identified and installed with the copper-colored end up. Push rods on late build vehicles and service push rods do not have a copper-colored end
and can be installed with either end up.
Apply clean engine oil to each end of the push rods and insert them into their respective positions.
4. Place a dab of multi-purpose grease in the fulcrum socket to hold the ball in place while installing the rocker arms.
5. NOTE: Apply clean engine oil to the top center of the valve bridges prior to installing the rocker arms.
NOTE: Always replace the rocker arm retaining clip with the same color clip.
Insert the rocker arm under the fulcrum and ball, rotate the rocker arm into place and position onto the push rod. Install a new rocker arm retaining
clip.
^
Repeat the step for the other rocker arm.
