F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
7. Remove the turbocharger inlet pipe mounting nuts and disconnect the vent tube.
^
To install, tighten to 13 Nm (10 ft. lbs.).
8. Loosen the clamp and remove the turbocharger inlet pipe.
9. Remove the fuel injector control module mounting bolts and position the module for access to the electrical connectors.
^
To install, tighten to 13 Nm (10 ft. lbs.).
10. Disconnect the fuel injector control module electrical connectors and remove the fuel injector control module.
