F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
Oil Cooler: Service and Repair
Oil Cooler
Material
Removal
1. Remove the intake manifold.
2. Remove the bolts and the exhaust gas recirculation (EGR) cooler supply port cover.
^
Remove and discard the press-in-place gasket.
^
Clean and inspect the sealing surfaces.
3. Remove the bolts and the oil filter base.
^
Remove and discard the press-in-place gasket.
^
Clean and inspect the sealing surfaces.
4. CAUTION: In the event of a catastrophic engine failure, always install a new oil cooler cover assembly (with oil cooler). Foreign material cannot
be removed from the oil cooler.
NOTE: The oil cooler is replaced as an assembly.
