F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
20. Position back the ground wire and install the retaining nuts.
21. Install the fuel injector control module. For additional information, refer to Computers and Control Systems.
22. Connect the engine coolant vent hose and clamp.
23. Connect the MAP sensor hose.
24. NOTE: Install a new O-ring seal on the heater hose tube.
Install the heater hose tube and the 2 bolts.
^
Tighten to 13 Nm (10 ft. lbs.).