F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
17. CAUTION: Sealant is used where the crankcase and the lower crankcase meet. Failure to cut the sealant could result in pulling the lower
crankcase seal out while removing the rear cover.
NOTE: A 139.7 mm (5.5 inch) long thin-blade scraper will be needed to correctly cut the sealant.
Use a thin-blade scraper to cut the sealant where the crankcase and the lower crankcase meet. Remove the rear cover.
^
Remove and discard the press-in-place gasket.
^
Clean and inspect the sealing surfaces.
Installation
All vehicles
1. Apply a bead of sealant at the back seam of the upper and lower crankcase.
2. Apply a bead of sealant at the oil pump cover joint.
