F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
3. NOTE: Do not tighten the nuts at this time.
NOTE: LH shown, RH similar.
Apply anti-seize lubricant to the turbocharger inlet Y-pipe bolts, then install the bolts and nuts.
4. Install the turbocharger. For additional information, refer to Fuel Delivery and Air Induction.
5. Tighten the turbocharger inlet Y-pipe nuts at the RH to LH joint.
^
Tighten to 27 Nm (20 ft. lbs.).
6. Install the rear FICM bracket and nuts to the LH valve cover.
^
Tighten to 8 Nm (71 inch lbs.).
7. Install the FICM For additional information, refer to Computers and Control Systems.
8. Check the system for leaks.