F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
ENGINE COOLANT TEMPERATURE (ECT) SENSOR
Removal
1. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
Turn the ignition switch to the OFF position.
2. Drain the engine cooling system.
3. Disconnect the cooling fan electrical connector.
4. Disconnect the engine coolant temperature (ECT) electrical connector.
5. Remove the ECT sensor and discard the O-ring seal.
Installation
1. NOTE: Apply clean engine oil to the new O-ring seal prior to installation.
Using a new O-ring seal, install the ECT sensor.
-
Tighten to 12 Nm (9 lb-ft).
2. Connect the ECT sensor electrical connector.