F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
7. Remove the fuel injector control module (FICM) nuts and bracket.
-
To install, tighten to 13 Nm (10 lb-ft).
8. Remove the FICM bolts.
-
To install, tighten to 13 Nm (10 lb-ft).
9. NOTICE: Make sure both latches are released before removing the electrical connectors or engine damage can occur.
Position out the FICM and disconnect the electrical connectors. Remove the FICM.
10. NOTICE: With the engine cold, fill vehicles without a yellow fill level decal on the degas bottle only to the MIN line. The correct fill level
on these vehicles is between the MIN line and 15 mm (0.59 in) below the MIN line. Fill vehicles with a yellow fill level decal to within the
yellow cold fill range shown on the decal. These fill levels will allow for coolant expansion. Overfilling the degas bottle may result in