F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
Removal and Installation
1. Disconnect the battery ground cable.
2. Disconnect the accelerator pedal and position sensor assembly electrical connector.
3. Disconnect the adjustable pedal motor electrical connector.
4. Disconnect the adjustable pedal motor drive cable from the brake pedal assembly.
5. Remove the 3 nuts and the accelerator pedal and position sensor assembly.
-
To install, tighten to 9 Nm (80 lb-in).
6. Remove the 3 bolts and the adjustable pedal motor and bracket assembly.
-
To install, tighten to 25 Nm (18 lb-ft).
7. To install, reverse the removal procedure.
-
The brake pedal and the accelerator pedal must be indexed when installing a new cable or a new adjustable pedal motor assembly. Index the
adjustable pedal assemblies.
