F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
7. Using the special tool, clean the fuel injector bore of deposits and hardened sealant.
8. Remove the fuel rail plug. Clean the fuel gallery with a wire brush. Use filtered compressed air to remove the foreign material from the gallery.
Install the fuel rail plug.
Installation
1. Verify the fuel injector bore is clean and dry.
2. Position the fuel injector sleeve onto the Injector Sleeve Replacer. Apply Threadlock 262 or equivalent to the very bottom (smallest diameter) and
very top (largest diameter) flat areas.
3. Position the fuel injector sleeve into the cylinder head fuel injector bore. Seat the fuel injector sleeve in the fuel injector bore, using a rubber
mallet. If any sealant gets into the inside of the injector sleeve, it must be cleaned out before it hardens.
