F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
4. Remove the bolts and the heat shield bracket.
5. Disconnect the fuel injection pressure regulator (IPR) valve electrical connector.
6. If equipped, disconnect the snap and remove the heat insulating wrap.
7. Using the special tool, remove the IPR valve.
-
To install, tighten to 50 Nm (37 lb-ft).
8. NOTE: It is necessary to re-install the heat insulating wrap on the IPR valve.
To install, reverse the removal procedure.
-
Apply clean engine oil to the IPR valve prior to installing.
