F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
4. Remove the bolt and position the battery negative cable aside.
-
To install, tighten to 47 Nm (35 lb-ft).
5. Disconnect the CKP sensor electrical connector.
6. Remove the bolt, the CKP sensor and discard the O-ring seal.
-
To install, tighten to 13 Nm (10 lb-ft).
7. NOTE: Apply clean engine oil to the O-ring seal prior to installation.
To install, reverse the removal procedure.
-
Install a new O-ring seal.
