F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these instructions could
increase the risk of injury in collisions.
1. Remove the cap from the safety belt buckle nut.
2. Remove the nut and the safety belt buckle.
-
To install, tighten to 55 Nm (41 lb-ft).
3. Remove the cap from the safety belt nut.
4. Remove the nut and the safety belt tongue.
-
To install, tighten to 55 Nm (41 lb-ft).
5. NOTE:
-
Make sure the safety belt webbing is not twisted prior to installation.
-
Make sure the safety belt is positioned in the retaining straps.
To install, reverse the removal procedure.
6. Check the active restraint system for correct operation.
Safety Belt - Rear, Supercab
SAFETY BELT - REAR, SUPERCAB
Removal and Installation
1. Remove the safety belt.