F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
7. Flush each transmission fluid cooler tube independently.
8. Connect the cleaner pressure and return tubes correctly.
1
Connect the pressure tube-to-fluid cooler inlet tube.
2
Connect the return tube-to-fluid cooler outlet tube.
3
Place the outlet end of the return tube in the fluid tank reservoir.
9. NOTE: Cycling the solvent pump on and off will help dislodge contaminants in the cooler system.
Switch the pumps on. Allow the fluid to circulate a minimum of 5 minutes.
10. Switch the pump off.
11. Disconnect the cleaner pressure tube at the fluid cooler tube.
12. Using compressed air, blow through the fluid cooler inlet tube until all fluid is removed.
13. Remove the rubber hoses from fluid cooler tubes.
14. Connect the cleaner pressure and return tubes correctly.
1
Connect the pressure tube to the radiator in-tank fluid cooler.
2
Connect the return tube to the other side of the radiator in-tank fluid cooler.
3
Place the outlet end of the return tube in the fluid tank reservoir.
15. NOTE: Cycling the pump on and off will help dislodge contaminants in the cooler system.
Switch the pumps on. Allow the fluid to circulate a minimum of 5 minutes.
16. Switch the pump off.
17. Disconnect the cleaner pressure tube at the fluid cooler tube.
18. Using compressed air, blow through the fluid cooler inlet tube until all fluid is removed.
19. Remove the rubber hoses from fluid cooler tubes.
20. Flush the remote filter manifold and make sure that the small bypass orifice is free of foreign material.
21. Flush the remote filter housing and clean the magnet.
22. Backflush and forward flush the OTA cooler.
23. Backflush and then forward flush the radiator in-tank cooler.
24. Install a new remote filter element.
25. Install a new OTA as part of a transmission service or installing a remanufactured transmission.
26. Carry out the transmission fluid cooler flow test.
