F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
5. Remove the center bearing support bolts.
6. Remove the rear driveshaft assembly.
7. GCAUTION: It may be necessary to tap the driveshaft yoke with a plastic or rubber soft-faced hammer if a pry area is not present on the
driveshaft yoke.
NOTE: Index-mark the driveshaft to transmission flange or output shaft to slip yoke.
For vehicles equipped with a circular flange, remove and discard the driveshaft-to-transmission bolts.
8. Remove the center bearing support bolts.
9. Remove the front driveshaft.
^
For vehicles equipped with a slip yoke, lower the driveshaft and slide it rearward off the transmission output shaft.
^
Plug the extension housing to prevent fluid loss.