F 450 2WD Super Duty V8-6.0L DSL Turbo VIN P (2006)
6. Position the rear driveshaft assembly and install the center support bearing bolts.
^
Hand-tighten only; do not tighten at this time.
7. Connect the rear driveshaft assembly to the front driveshaft. Install the new retainers and driveshaft-to-coupling shaft bolts.
^
Tighten to 35 Nm (26 lb-ft).
8. Connect the rear driveshaft assembly to the rear axle. Install the new retainers and driveshaft-to-axle bolts.
^
Tighten to 35 Nm (26 lb-ft).
9. Tighten the driveshaft center support bearing bolts to 63 Nm (46 lb-ft).