F 450 2WD Super Duty V8-6.4L DSL Turbo (2008)
7. CAUTION: Do not bend or flex the heater supply tube or damage to the tube may occur.
NOTE: Install a new O-ring seal.
Position the heater supply tube. Install the nut and bolt.
-
Tighten to 13 Nm (115 lb-in).
8. Position the engine wiring harness and install the bolt.
-
Tighten to 13 Nm (115 lb-in).
9. Connect the LH fuel charging harness electrical connector and pin-type retainer.
10. Connect the EOT and EOP sensor electrical connectors.
