F 450 2WD Super Duty V8-6.4L DSL Turbo (2008)
Alternator: Service and Repair
Generator - Single Generator
GENERATOR - SINGLE GENERATOR
Removal and Installation
1. Disconnect the batteries.
2. Remove the air cleaner assembly.
3. Remove the fender splash shield.
4. Rotate the accessory drive belt tensioner clockwise and remove the drive belt from the generator pulley.
5. Remove the nut and position the generator B+ terminal aside.
-
To install, tighten to 12 Nm (9 lb-ft).
6. Disconnect the generator electrical connector.
7. Remove the 2 lower bolts to the generator.
-
To install, tighten to 47 Nm (35 lb-ft).
8. Remove the upper bolt and the generator.
-
To install, tighten to 47 Nm (35 lb-ft).
9. To install, reverse the removal procedure.
