F 450 4WD Super Duty V10-6.8L VIN D (2004)
3
Install the bolts.
3. NOTE: If not secure within four minutes, the sealant must be removed and the sealing area cleaned. To clean the sealing area, follow the
directions provided on the packaging of the silicone gasket remover and the metal surface prep. Failure to follow this procedure can cause future
oil leakage.
Apply a bead of silicone gasket and sealant at the crankshaft rear seal retainer-to-cylinder block surface, at the locations shown.
4. NOTE: If not secure within four minutes, the sealant must be removed and the sealing area cleaned. To clean the sealing area, follow the
directions provided on the packaging of the silicone gasket remover and the metal surface prep. Failure to follow this procedure can cause future
oil leakage.
Apply a bead of silicone gasket and sealant at the engine front cover-to-cylinder block surface, at the locations shown.
5. NOTE: Be sure to tighten the bolts in two stages.
Tighten the bolts in the sequence shown.
^
Stage 1: Tighten to 20 Nm (15 ft. lbs.).
^
Stage 2: Tighten an additional 90°.
6. Position the RH engine mount on the engine and install the bolts.
^
Tighten the bolts to 80 Nm (59 ft. lbs.).
