F 450 4WD Super Duty V10-6.8L VIN D (2004)
21. Install the accelerator cable bracket.
^
Position the accelerator cable through the bulkhead.
^
Install the bolts.
22. Connect the accelerator cable routing clip to the dash panel stud.
23. Connect the accelerator cable to the accelerator pedal and shaft.
24. NOTE: The Idle Air Control Valve (IAC) is shown removed for clarity.
Position back the throttle body adapter.
^
Position a new throttle body adapter gasket.
^
Position the throttle body adapter.
^
Install four bolts and tighten in two stages.
^
Stage 1: Tighten to 9 Nm (80 inch lbs.).
^
Stage 2: Tighten an additional 90°.
