F 450 4WD Super Duty V10-6.8L VIN D (2004)
2. Remove the panel/defrost door vacuum control motor.
1
Disconnect the vacuum line.
2
Remove the pushnut.
3
Remove the screws.
4
Remove the panel/defrost door vacuum control motor.
INSTALLATION
1. NOTE: Install a new pushnut during installation.
Follow the removal procedure in reverse order.
Air Inlet Door
VACUUM CONTROL MOTOR - AIR INLET DOOR
REMOVAL
1. CAUTION: Do not attempt to bend any part of the lever. It is brittle and will break.
Remove the air inlet door vacuum control motor.
1
Disconnect the vacuum line.
2
Remove the screws.
3
Rotate the vacuum control motor to disengage the lever and remove the air inlet door vacuum control motor.
INSTALLATION
