F 450 4WD Super Duty V10-6.8L VIN D (2004)
3. NOTE: Lubricate the O-ring seals with mineral oil.
Install and connect the front auxiliary evaporator line(s) through the wheel well.
4. Snap the rear auxiliary evaporator inlet line into the brackets.
5. Install the brackets over the studs and loosely install the nuts.
6. CAUTION: Use a wrench on each side of the fitting to prevent damage to the A/C fitting.
NOTE: Lubricate the O-ring seals with mineral oil.
Connect the two auxiliary evaporator inlet lines.
7. CAUTION: Use a wrench on each side of the fitting to prevent damage to the A/C fitting.
