F 450 4WD Super Duty V10-6.8L VIN D (2004)
8. Disconnect the battery ground cable and wait at least one minute.
INSTALLATION
WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions and notes at the beginning of the removal
procedure.
1. Disconnect the battery ground cable and wait at least one minute.
2. Remove the restraint system diagnostic tools from the clockspring electrical connectors at the top of the steering column.
3. Install the driver air bag module.
1
Connect the horn electrical connector.
2
Connect the driver air bag module electrical connector.
3
Position the driver air bag module into the steering wheel.
4
Install the two bolts.
5
Install the two steering wheel back cover plugs.
4. Connect the battery ground cable.
5. With the restraint system diagnostic tools still installed at the remaining deployable devices, prove out the supplemental restraint system (SRS).
See: Air Bag(s) Arming and Disarming/Service and Repair/Prove Out Procedure
6. WARNING: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing
or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or
striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood
latches.
Please refer to the appropriate Component or System to determine location of the front air bag sensors.
The side impact sensors are located at or near the base of the B-pillar.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).
Disconnect the battery ground cable and wait at least one minute.
7. Restore the vehicle to operating condition.
1
WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the
supplemental restraint system (SRS) deactivation/reactivation procedure.
