F 450 4WD Super Duty V10-6.8L VIN D (2004)
8. NOTE: Prior to installation, make sure that the safety belt webbing is not twisted.
Position the safety belt anchor and install the bolt.
9. Remove the restraint system diagnostic tool from the safety belt retractor pretensioner floor electrical connector.
10. Connect the safety belt retractor pretensioner electrical connector.
11. NOTE:
-
Make sure that after an automatic locking retraction (ALR) retractor is installed, the retractor is not in the ALR mode of operation when
installed.
-
Prior to installation, make sure that the safety belt webbing is not twisted.
Position the safety belt retractor pretensioner and install the bolt.
