ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Seat Belt Retractor|Removal and Installation|Page 8094 > < Seat Belt Retractor|Removal and Installation
Page 2
background image

The side air bag sensors are located at or near the base of the B-pillar.

To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect auxiliary
batteries and power supplies (if equipped).

Disconnect the battery ground cable and wait at least one minute.

2

WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the
supplemental restraint system deactivation/reactivation procedure.

Deactivate the supplemental restraint system (SRS).

3

WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the seat
removal and installation procedure.

Remove the seat on the side with the affected safety belt retractor.

2. Remove the seat adjuster control knobs, covers and the seat side trim panel screws.

1

Remove the seat recliner lever cover screw and cover.

2

Pull to remove the lumbar control knob.

3

Remove the three seat side trim panel attachment screws (two shown).

3. Remove the two screws securing the lumbar adjuster control to the seat track riser.

-

Push the lumbar adjuster control inward to provide clearance for trim panel removal.

Vehicles with power seats

Seat Belt Retractor|Removal and Installation|Page 8094 > < Seat Belt Retractor|Removal and Installation