F 450 4WD Super Duty V10-6.8L VIN D (2004)
1. CAUTION: Use care not to get dirt in the rear axle housing.
Clean and inspect the rear anti-lock brake sensor.
1
Clean the axle mounting surface.
2
Inspect and clean the magnetized rear anti-lock brake sensor pole piece.
3
Inspect the rear anti-lock brake control O-ring for damage. Replace if necessary.
4
Lightly lubricate the rear anti-lock brake control O-ring with rear axle lubricant.
2. Install the rear anti-lock brake sensor.
1
NOTE: Do not apply force to the plastic rear anti-lock brake sensor connector.
Position the rear anti-lock brake sensor and install the rear anti-lock brake sensor bolt.
2
Connect the electrical connector.
3. NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
Connect the battery.
