F 450 4WD Super Duty V10-6.8L VIN D (2004)
1. Install the PAD switch.
1
Position the PAD switch to the instrument panel finish panel.
2
Install the screws.
2. Install the instrument panel finish panel.
3. Connect the battery ground cable.
4. With the restraint system diagnostic tools installed at all deployable devices, prove out the supplemental restraint system (SRS). See: Body and
Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair/Prove Out Procedure
5. Disconnect the battery ground cable and wait at least one minute.
6. Restore the vehicle to operating condition.
1
WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the
supplemental restraint system (SRS) deactivation/reactivation procedure.
Reactivate the supplemental restraint system (SRS).
2
WARNING: The restraint system diagnostic tool is for restraint system service only. Remove from the vehicle prior to road use.
Failure to remove could result in injury and possible violation of vehicle safety standards.
With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS). See: Body and Frame/Interior
Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair/Prove Out Procedure
