F 450 4WD Super Duty V10-6.8L VIN D (2004)
Tie Rod: Service and Repair
Outer - LH
Tie Rod End-Outer, LH, F-250, F-350, 4x4 and F-450, F-550
Special Tool(s)
Special Tool(s)
Removal
NOTE: Replace the tie rod end if the ball stud is loose in the socket or the tie rod end is bent. Replace the front suspension steering ball stud dust seal
if any nicks, cuts or tears are present. Do not attempt to straighten a bent tie rod end.
1. Position and lock the wheels in the straight-forward position. Raise and support the vehicle.
2. Remove the wheel.
3. Loosen the adjusting sleeve clamp.
4. Remove the cotter pin and castellated nut. Discard the cotter pin.
