F 450 4WD Super Duty V10-6.8L VIN D (2004)
2. Loosen the retaining bolts.
3. Raise the vehicle to the desired working height, keeping the axle parallel with the floor.
4. Release the parking brake.
5. Remove the wheel(s).
6. Remove the brake caliper and rotor on the single rear wheel axle.
7. Remove the retaining bolts and axle shaft.
8. CAUTION: The hub nuts are right-hand thread (right hub) and left-hand thread (left hub). Each hub nut is stamped RH or LH.
Install the Ford Axle Locknut Socket so that the drive tangs of the tool engage the four slots in the hub nut.
