F 450 4WD Super Duty V10-6.8L VIN D (2004)
2. NOTE: The extension housing bushing is model-dependent.
Using the special tool, install the extension housing bushing.
3. Align the extension housing seal in the extension housing, with the drain hole positioned downward.
4. Using the special tool, seat the extension housing seal.
5. Install the driveshaft.
6. Remove the supports and lower the vehicle.
7. Fill the transmission to the specified level with clean automatic transmission fluid, refer to the Fluid Capacity chart in Specifications.
Extension Housing Gasket
Extension Housing Gasket - F-Super Duty
Material
Removal
NOTE: The 4x2 application is shown, the 4x4 application is similar.
All vehicles
1. With the vehicle in NEUTRAL position it on a hoist. For additional information, refer Maintenance/Service and Repair.
