F 450 4WD Super Duty V10-6.8L VIN D (2004)
3. Connect the Output Shaft Speed (OSS) sensor.
4. CAUTION: Be sure not to raise the back of the transmission too high. If it makes contact with the underbody, damage to the TSS and OSS
sensors will occur.
Install the rear transmission mount.
1
Raise the transmission up.
2
Install the rear transmission mount.
3
Install the bolts.
5. Lower the transmission on to the rear crossmember support.
6. Install the transmission insulator and nuts.
7. Remove the transmission Jack from the transmission.
8. Install the driveshaft.
