F 450 4WD Super Duty V10-6.8L VIN D (2004)
9. Remove all but the two top carrier-to-axle housing retaining bolts, noting the length and position of each bolt.
^
Discard the differential carrier housing bolts.
10. WARNING: Secure the carrier to the jack to prevent it from falling when removing it from the axle housing. Failure to follow these
instructions may result in personal injury.
Remove the carrier from the axle housing.
1
Position a suitable jack under the carrier.
2
Remove and discard the remaining retaining bolts.
3
Use the slots to separate the carrier approximately 25.4 - 50.8 mm (1 - 2 inches) from the axle housing.
4
Secure the carrier to a suitable jack, and remove the carrier from the axle housing.
11. CAUTION: Alkaline cleaning solutions will damage machine surfaces. Use only emulsion cleaners or petroleum based cleaning solvent.
CAUTION: Use only soft, clean, lintless towels to dry the components.
CAUTION: After drying, lightly coat the parts with rust inhibitor or clean lubricant to prevent damage from corrosion. Wrap all parts that are
going to be in storage for a prolonged period in wax paper.
Clean and dry the components as necessary.
12. Inspect the gear set for pitting, scoring, wear and damage.
