F 450 4WD Super Duty V10-6.8L VIN D (2004)
1. NOTE: Install the Universal Joint Kits as complete assemblies only. Do not mix components from other Kits.
Install a new spider and bearing cup.
1
Start a new bearing cup in the shaft yoke.
^
Check the needle bearings for correct positioning.
2
Position the new spider in the shaft yoke.
3
Press the bearing cup to just below the snap ring groove.
2. NOTE: Use the yellow snap rings supplied in the kit to assemble the universal Joint (U-joint). If difficulty is encountered with the yellow snap
rings, install the black snap rings.
Remove the shaft from the special tool, and install the new snap ring.
Opposite bearing cup installation
3. Repeat Bearing cup installation in this procedure to install the new bearing cup and snap ring on the opposite side of the shaft yoke.
Slip-yoke installation
4. Inspect the driveshaft slip-yoke. Install a new yoke, if necessary.
