F 450 4WD Super Duty V10-6.8L VIN D (2004)
10. NOTE: Offset the Gauge Block to obtain an accurate reading.
Rotate the Gauge Block several half-turns to make sure the pinion bearings are correctly seated and position the Gauge Block.
11. Install the special tool.
1
Position the special tool.
2
Install the bearing caps.
3
Install the four bolts.
12. NOTE: Use a feeler gauge or flat, clean drive pinion position shims as a measuring device.
NOTE: Do not attempt to force the gauge or shim between the Gauge Block and the Gauge Tube. A slight drag indicates a correct selection.
Using a feeler gauge or flat, clean drive pinion position shims, measure between the Gauge Block and the Gauge Tube. Record the measurement.
Refer to Pinion Ring Gear Variation Number for shim selection information.
Remove the special tools after making the correct shim selection.
13. CAUTION: Follow the drive pinion bearing preload shim and drive pinion position shim assembly sequence as directed or unit failure can result.
Install the correct thickness drive pinion position shim, and the oil slinger, if so equipped, on the pinion.
